Every field the product has, each with its own control. Add a part to make a multi-part product (e.g. a showerhead and a pump), and connect its parts on the product.
Enter the real distance between the two points you picked.
The PDF is at its paper size. Enter its drawing scale 1:X to set the real-world size.
The drawing is at its own units. Enter its drawing scale 1:X to set the real-world size.
Products deleted from the shared database, each as it was when it was deleted. Restore brings one back under its own id, and the restore is logged.
Rename, recolour or delete the shared named colours, or add new ones. Changes sync to the database.
Paste a link to a heater datasheet PDF. StenalCAD reads the brand, model, dimensions and minimum clearances and adds it to your catalogue.
Your Anthropic API key stays on this computer and is used only for AI features such as datasheet import. Get one at console.anthropic.com.
Shared title-block templates (Baserow). The default one is applied to new sheets. Edit the layout directly on the sheet with “Edit title block”.
Saved sauna-bench slat compositions (doghe) and their skirting, shared via the database. Edit a preset's slats and skirting boards in the middle; the previews on the right show the slats from above and the bench from the side.
Benches made of a profile drawn in section (from the wall into the room, up from the floor) swept along the bench: a steam room’s list, and a sauna’s for its sculpted benches. Draw or edit a profile on the drawing, as one closed polygon standing on the floor against the wall, or import one from a DXF: a closed polyline, arcs included.
The pipes and ducts a connection can be made of. A physical connection takes its diameter and wall from its type; its elbows are drawn at the bend radius and its near-level runs fall at the slope.
The fittings a connection's end can be given, e.g. a G1/2" thread: a part asks for one, and the pipe table counts them.
These details are saved in the file and shown in the title bar.